STM Online Help: cstm Online Help (command-line interface)

MapLog
Syntax: maplog | ml
Use this command to view a record of all the devices identified when the system map was last built. You can view,
save, or print the log. The log is created at boot time, and whenever the RemapSystem command is executed.
The log displays the log creation time (e.g., "Fri Dec 9 13:27:31 1996"), followed by a list of log entries, describing
events which occurred during the system map build. The individual log entries are preceded by the day, date, and time
at which the logged event occurred. Log entries may contain information, error messages, tool status, etc.
See also RemapSystem.
Top
License
Syntax: license | lic [password {<stm licence password>}]
Use this command to install the level of licensing you need to run support tools. The password you enter will
determine the level of access the system grants you. All permissions granted you apply to the current test system only.
The password you type is not displayed on the screen.
See also HPLicense and DeinstallLic.
Licensing Password
In order to determine the level of access granted you by the system on which you have installed your support tools
license, you must enter a password at this time, and then enter "OK" to proceed. If you do not want to continue with
the password installation, enter "Cancel" instead.
The password you type is not displayed on the screen.
Top
HPLicense
Syntax: hplicense | hlic [password {<hp licence password>}]
Use this command to install the HP-Only license. HP-Only privileges will be enabled on all test systems accessed by
cstm, until the user interface is exited. On the User Interface (UI) system, however, the HP-Only password is only
enabled for the current session.
The password you type is not displayed.
See also License and DeinstallLic.
HP-Only Licensing Password
In order to enable HP-Only run privileges on all systems accessed by the STM until you exit the current login session,