STM Online Help: cstm Online Help (command-line interface)

Use "cancel" to abort the dialog.
If there are currently active interactive tools, you will be asked for confirmation before the system on which they are
running is disconnected.
Top
SaveMap
Syntax: savemap | smap [file {<full file path>}]
Use this command to write an ASCII copy of the device map to a specified file.
File Category
Save your configuration display information to a file by typing "savemap". You will be prompted for the name of the
file to which you wish to save your configuration. Enter the name of the file and type "Return".
Top
PrintMap
Syntax: printmap | pmap [printers {<printer name>}]
Use this command to print an ASCII copy of the device map to a specified printer. The list of available printers
includes all those configured on the system on which cstm is being run.
Printer
To print out a hardcopy of the device map to a particular printer, select a printer from the list displayed in the "Printer"
area of the screen display (selected printers are preceded by an asterisk) by typing its index number at the "Enter
Selection: (lp)" prompt; then type "ok".
Top
RemapSystem
Syntax: remapsystem | rs
Use this command to determine what hardware is attached to the unit under test. This command is especially useful
when you have attached new hardware to your system, or have powered up previously unpowered hardware. At the OS
prompt, issue an ioscan command, so that the system will recognize the new hardware; then run the Remap System
command in STM. Once the rescan is completed, the device map will be redisplayed. All devices are displayed and are
unselected.
Whenever this command is executed, the MapLog is created.
Top