Online Diagnostics (EMS and STM) Administrator's Guide September 2012
Table Of Contents
- Online Diagnostics B.11.31.19.04 Administrator Guide
- Contents
- 1 Introduction
- Overview
- Hardware Monitoring
- Support Tools Manager
- OnlineDiag Bundle Media
- 2 Installing the Online Diagnostics Software
- 3 Configuring and Administering EMS Hardware Monitors
- Configuring the Fibre Channel Monitors
- Hardware Monitoring Request Manager
- Configuring Hardware Monitoring
- Running the Monitoring Request Manager
- Enabling Monitoring
- Listing Monitor Descriptions
- Viewing Current Monitoring Requests
- Adding a Monitoring Request
- Modifying a Monitoring Request
- Verifying Hardware Event Monitoring
- Checking Detailed Monitoring Status
- Retrieving and Interpreting Event Messages
- Deleting Monitoring Requests
- Disabling Monitoring
- Peripheral Status Monitor
- Configuring the Peripheral Status Monitor
- 4 Administering the Support Tools Manager
- 5 Troubleshooting Online Diagnostics
- Glossary
- Index
- 6 Support and other resources
- 7 Documentation feedback
R
removing
FC switch, 26
FC-AL hub, 25
monitoring request, 45
swremove, 22
using the CLI, 22
using the TUI, 22
retrieving
event message, 37
running
support tool, 49
running a support tool
exeroptions, 62
special modes, 61
running monconfig, 32
S
special configuration
FC switch monitor, 25
FC-AL hub monitor, 24
starting STM, 48
STM
Failure Log, 52, 56
Read-Only Test, 51
Read-Write Test, 51
Support Tools Manager
see STM
U
using
set_fixed, 46
V
verifying installation
logfile, 21
STM, 48
swjob, 21
using the CLI, 21
using the TUI, 21
verifying removal
using the CLI, 23
using the TUI, 23
viewing
hardware monitoring, 36
monitor description, 33
monitoring request, 46
viewing the Failure Log
infofaillog, 60
viewing the test activity log
infoactlog, 60
71