Online Diagnostics (EMS and STM) Administrator's Guide September 2012
Table Of Contents
- Online Diagnostics B.11.31.19.04 Administrator Guide
- Contents
- 1 Introduction
- Overview
- Hardware Monitoring
- Support Tools Manager
- OnlineDiag Bundle Media
- 2 Installing the Online Diagnostics Software
- 3 Configuring and Administering EMS Hardware Monitors
- Configuring the Fibre Channel Monitors
- Hardware Monitoring Request Manager
- Configuring Hardware Monitoring
- Running the Monitoring Request Manager
- Enabling Monitoring
- Listing Monitor Descriptions
- Viewing Current Monitoring Requests
- Adding a Monitoring Request
- Modifying a Monitoring Request
- Verifying Hardware Event Monitoring
- Checking Detailed Monitoring Status
- Retrieving and Interpreting Event Messages
- Deleting Monitoring Requests
- Disabling Monitoring
- Peripheral Status Monitor
- Configuring the Peripheral Status Monitor
- 4 Administering the Support Tools Manager
- 5 Troubleshooting Online Diagnostics
- Glossary
- Index
- 6 Support and other resources
- 7 Documentation feedback
Verifying Removal of the Software
This section describes how to use the TUI and the CLI to verify whether the Online Diagnostics
software is removed successfully.
Verifying Removal Using the TUI
To use the TUI to verify whether the Online Diagnostics software is removed successfully, complete
the following steps:
1. Log in to the system as superuser.
2. Select Logfile in the Remove Window.
If there are no errors in the Logfile, the Online Diagnostics software is removed successfully.
If the Online Diagnostics software is not removed properly, you must repeat the removal
procedure. For instructions on how to remove the Online Diagnostics software, see “Removing
the Software” (page 22).
3. For information about errors related to the removal of the Online Diagnostics software, enter
the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying Removal Using the CLI
To use the CLI to verify whether the Online Diagnostics software is removed successfully, complete
the following steps:
1. Log in to the system as superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the Online Diagnostics software is removed successfully. If the
Online Diagnostics software is not removed properly, you must repeat the removal procedure.
For instructions on how to remove the Online Diagnostics software, see “Removing the Software”
(page 22).
3. For information about errors related to the removal of the Online Diagnostics software, enter
the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the output of the swjob command.
Verifying Removal of the Software 23