Online Diagnostics (EMS and STM) Administrator's Guide March 2013

1. Configure settings on one system using the monconfig utility.
The monitor /var/stm/config/tools/monitor/*.sapcfg file is created.
2. Modify the following configuration files, if required:
• /var/stm/config/tools/monitor/*.cfg, default_*.clcfg
• /var/stm/config/tools/monitor/Global.cfg
• /var/stm/data/tools/monitor/
NOTE: If you do not choose to modify these configuration files, the default values are used.
3. Copy all the /var/stm/config/tools/monitor/*.cfg, default_*.clcfg, and
*.sapcfg files on the new system. Do not copy a file with the name predictive, rst
(ISEE), wbem, or ovfn (HPEN) in the file name.
IMPORTANT: If you choose OpenView Configuration (OVC), you must set the initial
configuration on a system that has OVC installed. Otherwise, OVC will not be available for
use in the monconfig utility.
4. Enter the following command at the HP-UX prompt to enable the new configuration:
# /etc/opt/resmon/lbin/startcfg_client
Configuring the Peripheral Status Monitor 47