Online Diagnostics (EMS and STM) Administrator's Guide March 2012

Running Support Tools
You can run the support tools to obtain device-specific information, perform stress tests, and so on.
This section addresses the following topics:
• “Running a Support Tool Using the xstm Interface” (page 49)
• “Running a Support Tool Using the mstm Interface” (page 53)
• “Running a Support Tool Using the cstm Interface” (page 57)
• “Running a Support Tool in Special Modes” (page 61)
Running a Support Tool Using the xstm Interface
To run a support tool using the xstm interface, complete the following steps:
1. Enter the following command at the HP-UX prompt:
# /usr/sbin/xstm
The system map is displayed, as shown in Figure 4-1.
Figure 6 System Map (xstm Interface)
Running Support Tools 49