Release Notes for IPF Systems March 2010 Release

...
You can now run MAPPER, PERFVER, DFDUTIL, and COPYUTIL for the Qlogic 2.0X driver/card.
Example 4: Both the Qlogic 1.05 driver (version 00000105) and the Qlogic 2.0X driver (version 00000201) are
loaded. Unload the Qlogic 2.0X driver.
fs0:\> drivers
D Y C I
R P F A
V VERSION E G G #D #C DRIVER NAME IMAGE NAME
== ======== = = = == == =================================== ===================
...
46 00000105 D X X X 2 - HP 4 Gb Fibre Channel Driver S=00 B=38 D=1 F=0 I=2
8D 00000201 D X X X 2 - HP Fibre Channel Driver QlcFcFull
...
fs0:\> unload 8D
fs0:\> drivers
T D
D Y C I
R P F A
V VERSION E G G #D #C DRIVER NAME IMAGE NAME
== ======== = = = == == =================================== ===================
...
46 00000105 D X X X 2 - HP 4 Gb Fibre Channel Driver S=00 B=38 D=1 F=0 I=2
...
You can now run MAPPER, PERFVER, DFDUTIL, and COPYUTIL for the Qlogic 1.05 driver/card.
MAPPER
QXCR1000914112
The MAPNEW command for legacy FC devices does not show the proper WWN. This will be fixed in a later
release since it has a low impact.
PERFVER
QXCR1000766330
The PERFVER tool, when run with other ODE tools in multiple loops, intermittently skips testing a few devices
in section 1, in loop 2 or later loops. It does not skip any device in loop 1 and this defect only happens in
cellular systems.
PLUTODIAG
This version assumes that the system has PLUTO 2.0 or later version.
QXCR1000576887 (JAGag28741)
The PLUTODIAG tool crashes on systems when LBA is not present. This is an illegal configuration.
REODIAG
Sections 3, 5.11, and 5.12 does not run if the FTP or the PXE network driver is loaded. This behavior is by
design.
To run Sections 3, 5.11, and 5.12, reboot the cell without starting the FTP or PXE network driver.
If Sections 3, 5.11 and 5.12 are run, FTP access will not work until the machine is rebooted.
Sections 3.1 and 3.3 will not run if PXE network driver is loaded. This behavior is by design.
REODIAG checks for VenMsg(0C8AFAFB-2A49-43AA-A449-5B2FD20AE6C8) when executed from RAMDRIVE.
This value must be present for REODIAG to work from RAMDRIVE.