Offline Diagnostics Environment Administrator's and User's Guide

Example 4-8 Examining a Tool's Functions and Running the Tool
ODE> mapper2
***************************************************************************
****** ******
****** MAPPER2 ******
****** ******
****** Copyright (C) 2003-2006 by Hewlett-Packard Company ******
****** All Rights Reserved ******
****** ******
****** HP shall not be liable for any damages resulting from the ******
****** use of this program. ******
****** ******
****** Version B.01.02 ******
****** ******
***************************************************************************
Type HELP for command information.
MAPPER2 Help
Commands
--------
UTILINFO -- Display information about MAPPER
Continue ([y]/n)? y
ODE Commands Available from MAPPER2
Basic Commands
--------------
HELP -- Prints detailed information to the screen, when "help" <command>
or "help" <var> is typed
LS -- List modules available on boot medium
RUN -- Run a module (after setting desired environment variables)
Control-Y|Control-C -- Abort an ODE command; pause a module run
RESUME -- Restart a paused module
DISPLOG -- After running a module, display contents of a log
EXIT -- Return to next higher level prompt
Environmental Variables
-----------------------
SHOWSTATE -- Display the value of the following environment variables:
LOOP -- Run a test this many times
ERRPRINT [ON|OFF] -- Print low-level error messages to console
(primarily for manufacturing use)
ERRNUM [ON|OFF] -- Print one-line, numbered errors to the console
Continue ([y]/n)? y
ERRPAUSE [ON|OFF] -- Pause module upon error detection
ERRONLY [ON|OFF] -- Print ONLY error messages; disable non-error
and isolation message printing
INFOPRINT [ON|OFF] -- Print informational messages to the console
ISOPRINT [ON|OFF] -- Print fault isolation messages to the console
ISOPAUSE [ON|OFF] -- Pause module when isolation message is generated
LOGSIZE -- Set the size of a message log
DEFAULT -- Reset environment variables to default state
MAPPER2> help utilinfo
UTILINFO
Use this command to display information about the MAPPER utility.
MAPPER2> utilinfo
MAPPER is an ODE-based utility program. It is intended to display the con-
figuration of an HPPA system. This includes the path, identification, and
revision information of HPPA modules and peripheral devices. HPPA modules
include Processors, Memory Controllers, and I/O Modules (such as bus con-
Running ODE Tools on HP 9000 Systems 27