Dynamic workload movement with BladeSystem Matrix: Fluid movement between physical and virtual resources for flexibility and cost-effective recovery

22
If the administrator specifies „Virtual‟ as the value of this parameter, HP IR will choose a VM host as
the target for activating a cross-technology Logical Server during failover, and will choose a physical
server only if no VM host is available. If the value specified is „Physical‟, then a physical server is
preferred as the target.
By specifying the value „Virtual‟ for the recovery site and „Physical‟, the administrator can set up a
configuration where the protected cross-technology Logical Servers run on physical servers at the
primary site and VM hosts at the recovery site.