vparboot2.1m (2010 09)

v
vparboot2(1M)
For OA Based Partition Management Systems
vparboot2(1M)
ERRORS
OA syslog contains additional description of errors encountered during partition operations. Users can
view the OA syslog from the OA using "SHOW SYSLOG OA" command.
"Error: System unable to accept partition commands"
The above error message is printed out under the following circumstances:
• Attempting to run command from an OA other than the active OA in enclosure 1
• System has been shut down (e.g. with POWEROFF XFABRIC, or ambient overtemp)
• The OA has not finished initializing.
In the above scenarios, please ensure the system and OA are completely up and you are running the com-
mand from the active OA in enclosure 1.
vparboot displays error messages on standard error for any of the following conditions:
• vpar_id does not exist.
• vpar_id is in some run-state other than
DOWN, and so cannot be booted. Use the vparreset com-
mand instead.
• npar_id does not exist.
• The partition from where the command was invoked did not have sufficient
parperm privileges.
AUTHOR
vparboot was developed by the Hewlett-Packard Company.
SEE ALSO
On OA:
"help vparcreate", "help vparmodify", "help vparreset", "help vparremove", "help vparstatus", "help par-
perm".
On HP-UX:
parperm(1M), vparcreate2(1M), vparmodify2(1M), vparreset2(1M), vparremove2(1M), vparstatus2(1M).
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: September 2010