sigset.3c (2010 09)

s
sigset(3C) sigset(3C)
NAME
sigset(), sighold(), sigrelse(), sigignore() - signal management
SYNOPSIS
#include <signal.h>
void (*sigset(int sig, void (*func)(int)))(int);
int sighold(int sig);
int sigrelse(int sig);
int sigignore(int sig);
DESCRIPTION
The system defines a set of signals that can be delivered to a process. The set of signals is defined in sig-
nal(5), along with the meaning and side effects of each signal. An alternate mechanism for handling
these signals is defined here. The facilities described here should not be used in conjunction with the
other facilities described under signal (2) and sigspace (2).
sigset() allows the calling process to choose one of four ways to handle the receipt of a specific signal.
sig specifies the signal and func specifies the action handler.
sig can be any one of the signals described under signal (5) except
SIGKILL or SIGSTOP
.
func is assigned one of four values:
SIG_DFL, SIG_IGN, SIG_HOLD,orafunction address . The
actions prescribed by
SIG_DFL and SIG_IGN are described under signal (5). The action prescribed by
SIG_HOLD and function address are described below:
SIG_HOLD Hold signal.
The signal sig is held upon receipt. Any pending signal of this signal type remains
held. Only one signal of each type is held.
Note: the signals
SIGKILL, SIGCONT, and SIGSTOP cannot be held.
function address Catch signal.
func must be a pointer to a function, the signal-catching handler, that is called when
signal sig occurs.
sigset() specifies that the process calls this function upon
receipt of signal sig. Any pending signal of this type is released. This handler
address is retained across calls to the other signal management functions listed here.
Upon receipt of signal sig, the receiving process executes the signal-catching function
pointed to by func as described under signal (5) with the following differences:
Before calling the signal-catching handler, the defined action of sig is set to
SIG_HOLD. During a normal return from the signal-catching handler, the defined
action is restored to func and any held signal of this type is released. If a non-local
goto (longjmp (3C)) is taken, sigrelse() must be called to restore the defined
action to func and release any held signal of this type.
sighold() holds the signal sig. sigrelse() restores the defined action of sig to that specified pre-
viously by sigset(). sighold() and sigrelse() are used to establish critical regions of code.
sighold() is analogous to raising the priority level and deferring or holding a signal until the priority
is lowered by sigrelse().
sigignore() sets the action for signal sig to SIG_IGN (see signal (5)).
RETURN VALUE
Upon successful completion,
sigset() returns the previous value of the defined action for the specified
signal sig . Otherwise, a value of SIG_ERR is returned and errno is set to indicate the error.
SIG_ERR is defined in <signal.h>.
For the other functions, a 0 value indicates that the call succeeded. A -1 return value indicates an error
occurred and
errno is set to indicate the reason.
ERRORS
sigset() fails and the defined action for sig is not changed if any of the following occur:
[EFAULT] The func argument points to memory that is not a valid part of the process address
space. Reliable detection of this error is implementation dependent.
HP-UX 11i Version 3: September 2010 − 1 − Hewlett-Packard Company 1