scsimgr_estape.7 (2011 09)

s
scsimgr_estape(7) scsimgr_estape(7)
2 = Logpage 31 contains capacity informa-
tion
4 = Logpage 38 contains capacity informa-
tion
8 = Device supports Reserve/Release
Tape Density to write.
Default: 0x7f
0xFFFFFFFF = Best Density
0x00 = Let the device choose the density
0x7f = Do not modify tape density.
other = a valid density code for the Mode
Parameter Block Descriptor.
best_density RW uint32
Compression Algorithm to use
Default: 0
0x00 = Compression Disabled
0xDEF = default for drive
other = a valid compression value for the
Data Compression Mode Page (0x0F).
best_compression RW uint32
clean_req_
sns_info
The Key/Code/Qualifier representing
"Cleaning Required"
Default: 0xffffffff
RW uint32
Timeout for the space command.
Default: 1200
Device Set space_secs RW uint32
Timeout for all commands not referenced
below.
Default: 60
default_secs RW uint32
Timeout for the write command.
Default: 600
write_secs RW uint32
Timeout for the read command.
Default: 1200
read_secs RW uint32
Timeout for the unload command.
Default: 600
unload_secs RW uint32
Timeout for the rewind command.
Default: 600
rewind_secs RW uint32
Timeout for the erase command.
Default: 18000
erase_secs RW uint32
Default immediate reporting.
Default: 1
Values: 0 (disabled)
1 (enabled)
default_ir RW uint32
default_blocksize Default blocksize.
Default: 0
0 = variable, overridden by a custom DSF.
RW uint32
num_partitions
_supp
Number of partitions supported
Default: 1
Range: 1+
RW uint32
Tape Density to write.
Default: 0x7f
0xFFFFFFFF = Best Density
0x00 = Let the device choose the density
0x7f = Do not modify tape density.
other = a valid density code for the Mode
Parameter Block Descriptor.
best_density RW uint32
HP-UX 11i Version 3: September 2011 − 3 − Hewlett-Packard Company 3