ram_monitor.1m (2010 09)

r
ram_monitor(1M) ram_monitor(1M)
show profile Displays configured profiles of RIPng.
BGP-Specific Commands
The following are valid BGP-specific commands:
show filter Displays the list of BGP route filters.
show route Displays the BGP routing table.
trace (on|off) Toggles the tracing of the protocol daemon.
show log Displays the BGP protocol statistics.
show error Displays the list of notification sent to peers.
show peers Displays the list of BGP peers.
show eventlog Displays the list of BGP FSM transition events for all peers.
IS-IS-Specific Commands
The following are IS-IS-specific commands:
show adj Displays the isisd adjacency information.
show interface Displays the information on isisd interfaces.
show lsp Displays the LSP database for L1, L2, and L1/L2.
show log Displays isisd statistics.
show eventlog Displays the list of isisd cumulative event log.
show error Displays the list of cumulative errors.
show nexthop Displays the next hop list derived from the SPF calculation.
trace (on|off) Toggles the trace.
show filter Displays the list of isisd configured summary filters.
EXAMPLES
RIPng Examples
To invoke
ram_monitor and connect to ripngd, type the following at the HP-UX command prompt:
/usr/bin/ram_monitor ripng 15000
Following is sample output of the ram_monitor commands:
ripng> show interface
If : lan0
Status : UP, ENABLED
Profile : 0
Cost : 1
Mtu : 1500
Primary Address : fe80::230:6eff:fe2c:b619
Site Local Access : allow
Route Filter Access : deny
ripng> show route
5511::230:6eff:fe2c:b619/64 5511::230:6eff:fe2c:b619 1 local lan0
5555::230:6eff:fe2c:b619/64 5555::230:6eff:fe2c:b619 1 local lan0
6666::230:6eff:fe2c:b619/64 6666::230:6eff:fe2c:b619 1 local lan0
ripng> show profile
Profile id - 0
Horizon (2 - split/ 3 - poison reverse) : 3
Route Age (in sec) : 180
Periodic Update Timer Interval (in sec) : 30
Triggered Update Timer Interval (in sec) : 5
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: September 2010