parunlock.1m (2010 09)

p
parunlock(1M) parunlock(1M)
The -h option is required if this option is used.
If this option is specified, the command prompts for the password.
If an error is reported when you attempt to connect using this option, check to see
that IPMI LAN access has not been disabled on the remote service processor.
Access to the complex through IPMI over LAN can be enabled or disabled by log-
ging on to the service processor and using the
SA command from the Command
Menu.
The
-u and -g options are mutually exclusive.
-h IPaddress|hostname
This option should only be used in combination with either the
-u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target partition
(
-u) or complex (-g
).
-P Cancels any pending changes to the Stable Complex Configuration Data of the
target complex.
-s Unlocks the Stable Complex Configuration Data of the target complex.
-u username[:] Specifies the required authorization to access a partition other than the local par-
tition (but can also be used as a loopback access to the local partition). The com-
plex to be modified is the one in which this target partition resides.
The
-h option is required if this option is used.
If this option is specified, the command prompts for the password.
username specifies a configured user name on the target partition.
Note: This command is a Web-Based Enterprise Management (WBEM) Client
Application. The
-u option accesses the target partition using a Secure Sockets
Layer (SSL) connection. If errors are reported, check that the conditions
described in the DEPENDENCIES section are satisfied.
Mapping of Global Cell Numbers to Local Cell Numbers
The cabinets in a complex are numbered starting from 0. The cell slots in each cabinet are also numbered
starting from 0. Each cabinet can have a maximum of 8 cells. For example, the cells located in cabinet 0
will have the following cell numbers in global format: 0, 1, 2, 3, 4, 5, 6, 7. The cell numbers in
corresponding local format will be 0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7.
Similarly the cells located in cabinet 1 will have the following cell numbers in global format: 8, 9, 10, 11,
12, 13, 14, 15. The cell numbers in corresponding local format will be 1/0, 1/1, 1/2, 1/3, 1/4, 1/5, 1/6, 1/7.
From the above convention the cell located in cabinet 1, slot 0 is identified in the local format as 1/0 or in
the global format as 8. The
parstatus command will display the above cell as "cab1,cell0". The cell
located in cabinet 1, slot 4 is identified in the local format as 1/4 or in the global format as 12. The
par-
status command will display the above cell as "cab1,cell4". See parstatus (1).
RETURN VALUE
The
parunlock command exits with one of the following values:
0 Successful completion.
1 Error condition occurred.
EXAMPLES
Unlock the Partition Configuration Data of the partition whose partition number is
2.
parunlock -p 2
Unlock the cell data of the cell 2.
parunlock -c 2
Unlock the Stable Complex Configuration Data on the local complex.
parunlock -s
Unlock the Dynamic Complex Configuration Data on the local complex.
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: September 2010