parremove.1m (2010 09)

p
parremove(1M) parremove(1M)
-g Allows access to the complex specified by the
-h option. The accessed complex is
then considered the target complex. Access is through the service processor’s LAN
port.
The
-h option is required if this option is used.
If this option is specified, the command prompts for the password.
If an error is reported when you attempt to connect using this option, check to see
that IPMI LAN access has not been disabled on the remote service processor.
Access to the complex through IPMI over LAN can be enabled or disabled by logging
on to the service processor and using the
SA command from the Command Menu.
The
-u and -g options are mutually exclusive.
-h IPaddress|hostname
This option should only be used in combination with either the
-u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target partition
(
-u) or complex (
-g).
-k s_lock:p_lock Note: The
-k option is intended for use by system management tools which invoke
the
parremove command programmatically. Command line users should avoid
this option.
The
-k option specifies the lock keys provided by Partition Manager (
parmgr) for
Complex Configuration Data and Partition Configuration Data.
Lock keys should always be specified in pairs. If either lock key is not available,
enter
-1 as a placeholder. For example, if the s_lock key is available but the p_lock
key is not, then the option should be specified as
-k s_lock:-1
.
-u username[:] Specifies the required authorization to access a partition other than the local system
(but can also be used as a loopback access to the local partition). The complex to be
modified is the one in which this target partition resides.
The
-h option is required if this option is used.
If this option is specified, the command prompts for the password.
username specifies a configured user name on the target partition.
Note: This command is a Web-Based Enterprise Management (WBEM) Client
Application. The
-u option accesses the target partition using a Secure Sockets
Layer (SSL) connection. If errors are reported, check that the conditions described
in the DEPENDENCIES section are satisfied.
RETURN VALUE
The
parremove command exits with one of the following values:
0 Successful completion.
1 Error condition occurred.
EXAMPLES
Remove the inactive partition whose PartitionNumber is 2:
parremove -p 2
Remove an inactive partition in the same complex as the remote host Penzance :
parremove -p 0 -u RemoteAdmin: -h Penzance
RemoteAdmin must have superuser permissions on Penzance . The command prompts for the password.
DEPENDENCIES
This command uses the Web-Based Enterprise Management (WBEM) product and some of its
configuration settings. If you encounter connection errors when using the
-u option, check that the fol-
lowing two conditions are satisfied:
• Use the
cimconfig command (see cimconfig(1M) in the WBEM product documentation) to verify
(and correct if necessary) the setting of the following two variables:
•
enableRemotePrivilegedUserAccess=true
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: September 2010