nwmgr_vlan.1m (2010 09)

n
nwmgr_vlan(1M) nwmgr_vlan(1M)
The valid range is 0-7.
The default is 0.
pri_override=
level Priority override provides a mechanism to convert IP level precedence (IPV4
ToS octet) to link level 802.1p user priority.
Priority override applies to outbound frames only. Priority override level
strings are:
CONF_PRI Your specified priority value will be used. This is the default
value.
IP_HEADER IP header ToS will be converted to 802.1p priority.
CONF_TOS Your specified ToS value will be converted to 802.1 priority.
speed Speed and duplex of the related interface. For 10 Mbps, 100 Mbps, and multi-
ple of 10 and 100 Mbps, the speed is displayed in Mbps. For 1 Gbps and
above, the speed is displayed in Gbps. The duplexity can be either "half" or
"full".
Only valid for the
get operation.
timeout=seconds Specifies how many seconds to wait for acknowledgement of each test frame
for the diagnose operation.
The default is 5 seconds.
tos=ToS_value Specifies the IP precedence in the IP header. Switches ignore ToS. Routers
may use it.
The valid range is 0-255.
The default is 0.
tos_override=level ToS override provides a mechanism to override the IP level precedence in the
header of an inbound IP packet. ToS override level strings are:
IP_HEADER ToS value in the IP header will be used. This is the
default value.
ETHER_HEADER Ether header 802.1p priority will be converted to a ToS
value.
CONF_TOS Your specified ToS value will be used.
CONF_PRI Your specified 802.1 priority value will be converted to a
ToS value.
vlanid=vlanid Uniquely identifies the VLAN to which a frame belongs.
USAGE
The common usages of nwmgr for VLAN interfaces are described in this section.
Add a VLAN Interface
nwmgr -a -S vlan [-c lanVPPA] -A vlanid=vlanid , ppa=PPA [,attr=value...] [--sc]
nwmgr --add --subsystem vlan [--class_instance lanVPPA]
-A vlanid=vlanid , ppa=PPA [,attr=value...] [--sc]
This command adds a VLAN interface over a VLAN capable interface. If a VPPA (virtual PPA) is
specified as a target with the
-c option, the VLAN interface added will be allocated that VPPA. If
the -c option is not specified, the VPPA is allocated by the system.
The valid attributes (specified with the
-A option) for the add operation are:
ppa=PPA
vlanid=vlanid
pri=priority
tos=ToS_value
name=name
tos_override=level
pri_override=level
HP-UX 11i Version 3: September 2010 − 3 − Hewlett-Packard Company 3