nwmgr_ixgbe.1m (2010 09)

n
nwmgr_ixgbe(1M) nwmgr_ixgbe(1M)
Min: 0
Max: 65535
Default: 64
rx_frc_c RX Frame Count C. Frame Count for receive interrupt coalescing for Range R2 -
R3%.
Min: 0
Max: 65535
Default: 128
rx_frc_d RX Frame Count D. Frame Count for receive interrupt coalescing for Range R3 -
100%
Min: 0
Max: 65535
Default: 512
rx_r1 RX Range Limit 1. Link-utilization range limit 1 (R1) for receive interrupt coalesc-
ing: 0 - R1 - R2 - R3 - 100%.
rx_r1 must be less than rx_r2.
Min: 0
Max: 100
Default: 5
rx_r2 RX Range Limit 2. Link-utilization range limit 2 (R2) for receive interrupt coalesc-
ing: 0 - R1 - R2 - R3 - 100%.
rx_r2 must be less than rx_r3.
Min: 0
Max: 100
Default: 25
rx_r3 RX Range Limit 3. Link-utilization range limit 3 (R3) for receive interrupt coalesc-
ing: 0 - R1 - R2 - R3 - 100%.
Min: 0 Max: 100
Default: 70
rx_timer RX Timer Interrupt. The time interval between receive interrupts. Units in
microseconds. Setting to 0 disables the timer.
Min: 0
Max: 32000000
Default: 100
speed Speed, Duplex and Autonegotiation. Actual values of speed and duplex if the link is
up; the configured values otherwise. Note that, for 10GBase-SR, the speed is
always fixed at 10 Gbps, and the duplex is always Full. This value is read-only.
tx_cko Transmit Checksum Offload. Hardware TCP/UDP (IPv4) transmit checksum
offload.
Values:Off,On
Default: On
tx_fctrl Transmit Flow Control. Ability of the interface to transmit Ethernet Flow control
frames.
Values:Off,On
Default: On (case insensitive)
When configured, the adapter automatically generates a pause frame when the
amount of data in the receive queue exceeds the threshold
fctrl_thresh.
tx_frc_a TX Frame Count A. Frame Count for transmit interrupt coalescing for Range 0 -
R1%.
Min: 0
Max: 65535
4 Hewlett-Packard Company − 4 − HP-UX 11i Version 3: September 2010