nwmgr_iqxgbe.1m (2011 09)

n
nwmgr_iqxgbe(1M) nwmgr_iqxgbe(1M)
Default: 1500
pktsize=bytes Specifies the packet size in bytes of each test frame. The default packet size is
current MTU-3. Only valid for the diagnose
operation.
intr_coal Interrupt Coalesce Ticks: Maximum time for the NIC to wait after receiving a
frame before it raises an interrupt.
Minimum: 0
Max: 65535
Default: 0
drv_mq Number of Queues Number of hardware queues configured on adapter
Minimum: 1
Max: 4
Default: 4
rx_cko Receive Checksum Offload: Hardware TCP/UDP (IPv4) receive checksum
offload.
Values:Off,On
Default: On
tx_cko Transmit Checksum Offload: Hardware TCP/UDP (IPv4) transmit checksum
offload.
Values:Off,On
Default: On
drv_lro TCP Packet Reassembly: TCP Packet Reassembly in hardware
Values:Off,On
Default: On
auto_reco Auto Recovery Initiating automatic recovery when adapter becomes non-
operational
Values:Off,On
Default: On
ifadmin Administration Status: The Administration Status of a link. The default value
will be UP (1) if the card is claimed succussfully.
Values: UP, DOWN
Default: UP
Example:
nwmgr -s -A {ifadmin= UP | DOWN } -c lanPPA
Set the new Administration Status for
PPA. The Administration Status value
must be
UP or DOWN. Alternatively, it can be 1 or 0, respectively.
vmtu Virtual MTU for TCP Segmentation Offload (TSO). Setting it to zero disables
TSO. Setting it to a non-zero value enables TSO.
Values: 0, 32160
Default: 32160
Display Network Interfaces
This command displays netowrk interface without any arguments.
nwmgr
The command without any arguments displays all the network interfaces in the system, including
physical LAN interfaces (NICs), virtual LAN interfaces (VLANs and APA aggregates), and RDMA-
based interfaces.
View Basic Properties of One or More Interfaces
The following command displays basic properties of interfaces
nwmgr [-g][-v][-c lanPPA | -S iqxgbe]
nwmgr [--get][--verbose][--class_instance lanPPA | --subsystem iqxgbe]
HP-UX 11i Version 3: September 2011 − 3 − Hewlett-Packard Company 3