nwmgr_iexgbe.1m (2011 09)

n
nwmgr_iexgbe(1M) nwmgr_iexgbe(1M)
Jumbo receive must be off before turning on
drv_pr.
Values:Off,On
Default: Off
ifadmin Administration Status: The Administration Status of a link. The default value will
be UP (1) if the card is claimed succussfully.
Values: UP, DOWN
Default: UP
Example:
nwmgr -s -A {ifadmin= UP | DOWN
} -c lanPPA
Set the new Administration Status for
PPA. The Administration Status value must
be
UP or DOWN. Alternatively, it can be
1 or
0, respectively.
mac MAC Address: Ethernet MAC Address. The default value is the factory MAC
address.
mtu MTU: Maximum Ethernet payload size, in bytes. Valid values are 257 - 1500 and
9000.
Default: 1500
9000 bytes is the value to use for Jumbo Frames.
pktsize=bytes Specifies the packet size in bytes of each test frame. The default is 100. Only valid
for the diagnose operation.
rx_cko Receive Checksum Offload. Hardware TCP/UDP (IPv4) receive checksum offload.
Values:Off,On
Default: On
rx_fctrl Receive Flow Control. Ability of the interface to receive Ethernet flow control
frames. This option is not support for this release.
Values:Off,On
Default: On (case insensitive)
rx_timer RX Interrupt Timer. For receive interrupt coalescing, the minimum time between
receive interrupts. Units in microseconds. Setting to 1 disables the timer, the dev-
ice will schedule an interrupt immediately after receiving a packet.
Min: 1
Max: 3000
Default: 25
speed Speed, Duplex and Autonegotiation. Actual values of speed and duplex if the link is
up; the configured values otherwise. Note that, for 10GBase-SR, the speed is
always fixed at 10 Gbps, and the duplex is always Full. This value is read-only.
tx_cko Transmit Checksum Offload. Hardware TCP/UDP (IPv4) transmit checksum
offload.
Values:Off,On
Default: On
tx_fctrl Transmit Flow Control. Ability of the interface to transmit Ethernet flow control
frames. This option is not supported for this release.
Values:Off,On
Default: On (case insensitive)
When configured, the adapter automatically generates a pause frame when the
amount of data in the receive queue exceeds the threshold
tx_timer TX Interrupt Timer. For transmit interrupt coalescing, the minimum time between
transmit interrupts. Units in microseconds. Setting to 0 disables the timer, the
device will schedule an interrupt immediately after completing a packet transmit
request.
Min: 1
HP-UX 11i Version 3: September 2011 − 3 − Hewlett-Packard Company 3