netmgr_apa.1m (2010 09)

n
nwmgr_apa(1M) nwmgr_apa(1M)
Maximum Transmission Unit. Maximum Ethernet payload
size, in bytes.
mtu -g
Network Management ID of the link.nmid -g
Normalized Port Cost. The value is calculated by dividing
port_cost by the link’s speed. This is used by cost-based
failover groups to choose the active port. The lower the
normalized port cost, the more preferred the port.
norm_port_cost -g
Operational Key. Key value currently in active use for
aggregating ports with LACP_AUTO mode.
oper_key -g
Parent Link Aggregate.parent_ppa -g
Payload size (in bytes) of each test frame.
Min: 1, Max: MTU-3 Default: MTU-3.
pktsize --diag
Polling Interval. Time interval in seconds between two pol-
ling packets are sent. The interval may be expressed as a
decimal value.
Min: 0.5, Max: 2147.0 Default: 10.0.
poll_interval -a -g
Port’s cost. A value chosen to reflect the efciency for a port
to carry traffic. The lower cost, the more efficient is the
port.
Min: 1, Max: 100 Default: none.
port_cost -a -g -s
Port’s priority. An integer value greater or equal to 0. The
higher the value, more preferred the port is.
Min: 0, Max: 255 Default: none.
port_pri -a -g -s
Rapid ARP. Flag to indicate if gratuitous ARP packets are
to be sent per rapid ARP interval and count settings when
the mac_address of failover groups changing.
Values: on, off. Default: on.
rapid_arp -a -g
Rapid ARP Count. Number of rapid gratuitous ARP pack-
ets to send.
Min: 5, Max: 60 Default: 10.
rapid_arp_count -a -g
Rapid ARP Interval. Number of seconds (in decimal)
between the transmission of rapid gratuitous ARP packets.
Min: 1.0, Max: 4.0 Default: 1.0.
rapid_arp_interval -a -g
Speed and Duplex. Actual speed and duplex values of the
interface. For speeds between 10 and 100 Mb/s, it is
displayed in units of Mb/s. For speed greater or equal to
1000, it is displayed in units of Gb/s.
speed -g
LACP Port System Priority LACP system priority gives con-
trol to the system to resolve standby ports to be added in a
link aggregate.
Min: 0, Max: 65535 Default: none.
sys_pri -g -s
Specify the number of seconds to wait for the acknowledge-
ment of each test frame.
Min: 1, Max: none Default: 2
timeout --diag
6 Hewlett-Packard Company 6 HP-UX 11i Version 3: September 2010