netmgr_apa.1m (2010 09)

n
nwmgr_apa(1M) nwmgr_apa(1M)
In addition, the quantity throughput can be displayed along with the
packet counter, using counter values of p:t
. However, with this
counter value (
p:t), the physerr value is not allowed.
The
value argument specifies how the quantities are to be displayed.
The delta (default) displays the change in quantities since the previous
display. The current displays the change in quantities since the last
reset of the linkaggregate. The
rebase displays the change in quanti-
ties since the invocation of the command.
-S | --subsystem Specifies the target subsystem for the operation. For APA subsystem, the
option argument is always:
apa.
--sa | --saved Specifies that the operation must be performed on the saved
configuration (persistent store).
-sc | --script Displays the output in script friendly format.
--st | --stats Specifies that the operation applies to the statistics of the target.
-v | --verbose Specifies verbose output to display more detail.
--wr | --wrap Displays statistics output counter for monitor mode in its full width in
one line even when it is more than the terminal width.
Attributes
Different operations allow different attributes to be specified in the command line. The following table
describes the attributes supported by
nwmgr for APA:
The Commands column lists the APA
nwmgr operations supported for the attribute. The description of
the attribute is in the third column.
Attribute Commands Description
Dead Count. Number of polling packets to miss before con-
sidering a port to be down.
Min: 2, Max: 65535 Default: 3
dead_count -a -g
(Global) Default Port Mode. Default mode of every port
that supports APA. This attribute is equivalent to the
HP_APA_DEFAULT_PORT_MODE found in the
/etc/rc.config.d/hp_apaconf
configuration file.
Values: LACP_AUTO, FEC_AUTO , MANUAL, LAN_MONITOR .
Default: MANUAL.
default_mode -g -s
The MAC address of the LAN interface target.dest --diag
The policy to select active port for the failover group. The
policy could be cost-based or priority-based. If all ports in a
failover group have no cost defined, the default failover pol-
icy as priority-based is used.
failover_policy -g
Features. Supported features to compare. VLAN - Virtual
LAN; CS4 - Send CKO for IPv4; CS6 - Send CKO for IPv6;
CR4 - Receive CKO for IPv4; CR6 for Receive CKO for IPv6.
features -g
Fixed-MAC Mode. Used with the mac attribute to assign
the MAC address of the APA interface.
Values: on off
Default: off.
fixed_mac -g -s
4 Hewlett-Packard Company − 4 − HP-UX 11i Version 3: September 2010