make_sys_image.1m (2012 03)

m
make_sys_image(1M) make_sys_image(1M)
/.profile
/etc/rc.config.d/hpetherconf
/etc/rc.config.d/hpfcgsc_lanconf
/etc/rc.config.d/hpfcmsconf
/etc/rc.config.d/netconf
/etc/rc.config.d/netdaemons
/etc/rc.config.d/namesvrs
/etc/rc.config.d/mailservs
/etc/rc.config.d/xfs
/etc/hosts
/etc/mail/sendmail.cw
/etc/ntp.conf
/etc/vue/config
/var/adm/sw/security
The default level is 2. If any of the above is a directory, then all files below that
directory will be reset. However permissions will be preserved as to what the origi-
nal file had in those cases where the original file permissions differ from the
newconfig version.
-n filename The filename of the archive file other than the default host name. If the
-d option
is a device file, the
-n option is ignored.
Note: When the -n option is used, a .Z or .gz is not automatically appended to
the file name; it must be added manually.
-r remsh_user remsh user name. This is the user name used for remsh commands. If this option
is omitted, the current user name is used.
-m c | t | p Archive method: c for cpio, p for pax, and t
for tar. tar is the default.
-c z | g | n Compression method: z for compress, g for gzip
,or n for no compression.
gzip is the default.
-a archive_size
The calculated size required for the archive may be passed to this command. The
archive size must be a decimal number. The archive size is usually created by run-
ning the /opt/ignite/lbin/list_expander -s
command. This will save
one call to
list_expander during
make_sys_image’s execution.
-R Run make_sys_image in recovery mode. This will set the level of clean up to
1, over-
riding the
-l option value. This option is required if using the -g option.
-g file_list The indicated file contains a list of files to be archived. This list should be gen-
erated by a call to the list_expander
command. The file may either contain
the name of the file or directory only, or it may contain an entire line of information
in the form of: [<
fl_name_len>] <file_name> [<mode> <last-mod>
<bytes> <blocks> [<cksum>]]. The -R option must precede the -g option.
-t y|n|o|p Test for the existence of a needed pax patch.
y Yes, run the tests along with make_sys_image (this is the default).
n No, do not run the tests. This may be used on clients that the user knows con-
tain the patch.
o Run the tests only; that is, do not make a system image. It always exits and
returns a 4 if a patch exists that fixes a pax defect; a 3 if it is an enablement
patch (for example PAX-Enh on B.11.23); a 1 if the requested format is not
allowed on this system and a 0 if there are no pax patch(es) that the system
requires or could use.
p Run the tests only; prompt for cancel if a pax patch is required or could be
applied to the system. It always exits after the prompt, and returns the same
values as the o option exception if the patch(es) listed are non-enablement
patches it will return a 3 if the user answered [yY]tocancel.
-p Preview mode; performs all of the checks and creates the command line, but does
not modify any files other than the make_sys_image.log.
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: March 2012