lanqueryconf.1m (2010 09)

ManualsBrandsHP ManualsSoftwareHP-UX Manpages

lanqueryconf(1M) lanqueryconf(1M)

Sample File

The ﬁle speciﬁes failover groups

lan900, lan901, lan902, lan905, and lan1 with total number of 2,

4, 2, 2, and 1 ports in each, respectively. The ﬁrst network interface listed is the primary and the subse-

quent ones are the standby interfaces.

Failover groups

lan902, and lan905, have polling interval of 5 seconds and dead count of 2;

lan900

and lan901 have polling interval of 10 seconds and dead count of 3.

RAPID_ARP is enabled (on). There

are IP addresses preconﬁgured on the primary ports of lan900 and lan905. There are no IP address

preconﬁgured on the primary ports of lan901 and lan902.

lan902 is a cost-based failover group. The cost values are preceded by a colon (

:) and a space. The pri-

mary port has the lowest cost.

lan905 is also a cost-based failover group. The primary port and the standby port have the same cost,

but the primary port has higher priority.

When the failover group is created, the normalized cost determines which port will be the active port; it

might not be the one designated as

PRIMARY

in the ASCII conﬁguration ﬁle. When the failover group is

cleared, the IP address switches back to the port speciﬁed as PRIMARY in the ASCII ﬁle if the primary

port preconﬁgured IP address when creating the failover group.

lan1 is a single-port failover group, no aggregate is allocated for it.

POLLING_INTERVAL 10000000

DEAD_COUNT 3

LM_RAPID_ARP on

LM_RAPID_ARP_INTERVAL 1000000

LM_RAPID_ARP_COUNT 10

FAILOVER_GROUP lan1

STATIONARY_IP 193.12.14.54

FAILOVER_GROUP lan900

STATIONARY_IP 194.12.14.55

PRIMARY lan2 5

STANDBY lan3 3

FAILOVER_GROUP lan901

PRIMARY lan4 5

STANDBY lan5 4

STANDBY lan7 3

STANDBY lan6 3

POLLING_INTERVAL 5000000

DEAD_COUNT 2

FAILOVER_GROUP lan902

PRIMARY lan903 5 : 2

STANDBY lan904 3 : 3

FAILOVER_GROUP lan905

STATIONARY_IP 192.12.14.56

PRIMARY lan907 9 : 3

STANDBY lan908 7 : 3

AUTHOR

lanqueryconf was developed by HP.