lanadmin.1m (2010 09)

lanadmin(1M) lanadmin(1M)

(TO BE OBSOLETED)

verbose Restore the display of command menus.

LAN Interface Test Mode Menu

The following commands are available:

clear Clear the LAN interface network statistics registers to zero. You must be a

privileged user.

display Display the RFC 1213 MIB II statistics. Depending on the link, the type-speciﬁc

MIB statistics may also be displayed. For instance, for Ethernet links, the RFC

1398 Ethernet-like statistics are displayed.

end Return lanadmin to Test Selection Mode.

menu Display the LAN Interface Test Mode command menu.

ppa Prompt for a PPA that corresponds to a LAN interface card. It defaults to the ﬁrst

LAN interface encountered in an internal list. Appropriate values can be

displayed with the

lanscan command (see lanscan (1M)).

quit Terminate the

lanadmin program.

reset Reset the local LAN interface card, causing it to execute its self-test. Local access

to the network is interrupted during execution of reset. You must be a

privileged user.

specific Display and execute commands from a driver specific menu.

Arguments

lanadmin recognizes the following Immediate Mode argument.

PPA The Physical Point of Attachment (PPA) number of the LAN interface. This argu-

ment is ignored if none of the

aAcgmMprRsSVxX

options are used (Menu Mode).

Any options speciﬁed after PPA are ignored. Appropriate values can be displayed

with the

lanscan command (see lanscan (1M)).

WARNINGS

Changes made to an interface’s station address or mtu with the

lanadmin command will not be

preserved between system reboots. A user must modify the initialization conﬁguration ﬁles for this

feature, either manually editing conﬁguration ﬁles or through the

SAM interface.

Obsolescence

The

lanadmin, lanscan, and linkloop commands are deprecated. These commands will be

removed in a future HP-UX release. HP recommends the use of replacement command nwmgr(1M) to

perform all network interface-related tasks.

AUTHOR

lanadmin was developed by HP.