hpux.1m (2010 09)

h
hpux(1M) hpux(1M)
(PA-RISC Systems Only)
10 seconds expired.
Proceeding...
Booting...
Boot IO Dependent Code (IODC) revision 8
HARD Booted.
ISL Revision A.00.44 Mar 12, 2003
ISL booting hpux
hpux, the secondary system loader, then announces the operation it is performing, in this case
boot, the
devicefile from which the load image comes, and the
TEXT size, DATA size, BSS size, and start address of
the load image, as shown below, before control is passed to the image.
Boot
: disk(0/5/1/0.1342185441.1342359545.1074003968.0.0.0;0)/stand/vmunix
17838080 + 4132864 + 10284088 start 0x3c0e8
The loaded image then displays numerous configuration and status messages.
Interactive Boot
To use
hpux interactively,
isl must be brought up in interactive mode by pressing any key during the
interval allowed by
pdc. pdc then displays the primary, alternate, and if applicale, HA boot devices and
presents the pdc Main Menu. The bootpath may be chosen using
BOot [PRI|HAA|ALT|<path>]
.
such as
Main Menu: Enter command or menu >
bo pri
or
Main Menu: Enter command or menu >
bo 0/5/1/0.1
A search can also be done for boot devices:
Main Menu: Enter command or menu >
search
Potential boot devices are then displayed:
Path# Device Path (dec) Device Type Rev
----- ----------------- ----------- ----
P0 0/0/0/1/0.15.1.135.118 LAN Module 6
P1 0/0/0/2/0.6 Random access media 4
P2 0/0/1/1/1.0 Fibre Channel Protocol 8
The boot path may be chosen by
Main Menu: Enter command or menu >
bo p1
Although all of the operations and options of hpux can be used from isl interactively, they can also be
executed from an
autoexecute file. In the examples below, user input is the remainder of the line
after each ISL> prompt shown. The remainder of each example is text displayed by the system. Before
going over specific examples of the various options and operations of hpux, here is an outline of the steps
taken in the automatic boot process. Although the hardware configuration and boot paths shown are for a
single server machine, the user interfaces are consistent across all models. When the system Reset but-
ton is depressed, pdc executes self-test, and assuming the hardware tests pass, pdc announces itself,
and gives the user 10 seconds to override the autoboot sequence by entering any character. Text
resembling the following is displayed on the console:
Central Bus Speed (in MHz) : 200
Available Memory : 7340032 KB
Good Memory Required : Not initialized. Defaults to 32 MB.
Primary boot path: 0/5/1/0.1
Alternate boot path: 0/5/1/0.2
Console path: 0/0/1/1.0
Keyboard path: 0/0/4/0.0
Processor is starting the autoboot process.
To discontinue, press any key within 10 seconds.
HP-UX 11i Version 3: September 2010 − 5 − Hewlett-Packard Company 5