getx25.1m (2010 09)

getx25(1M) getx25(1M)

(TO BE OBSOLETED)

NAME

getx25 - get x25 line

SYNOPSIS

/usr/sbin/getx25

line speed pad-type

DESCRIPTION

The

uucp commands, including getx25, are targeted for removal from HP-UX; see the WARNINGS

below.

getx25 is functionally very similar to getty

(see getty (1M)) but is used only for incoming lines that are

connected to an X.25 PAD. It performs special functions such as setting up an initial PAD conﬁguration.

It also logs the number of the caller in

/var/uucp/.Log/LOGX25

. The third parameter is the name of

the PAD being used. HP 2334A is the only one supported at this time. A typical invocation would be:

/usr/sbin/getx25 x25.1 2 HP2334A

WARNINGS

Use of uucp commands, including getx25, is discouraged because they are targeted for removal from

HP-UX. Use ftp (1) or rcp(1) instead.

AUTHOR

getx25 was developed by HP.

PAGE 1
getx25(1M) getx25(1M) (TO BE OBSOLETED) NAME getx25 - get x25 line SYNOPSIS /usr/sbin/getx25 line speed pad-type DESCRIPTION The uucp commands, including getx25, are targeted for removal from HP-UX; see the WARNINGS below. getx25 is functionally very similar to getty (see getty (1M)) but is used only for incoming lines that are connected to an X.25 PAD. It performs special functions such as setting up an initial PAD configuration. It also logs the number of the caller in /var/uucp/.Log/LOGX25.
PAGE 2
(Notes) A (Notes) gA 2 Hewlett-Packard Company −1− HP-UX 11i Version 3: September 2010