disksecn.1m (2010 09)

d
disksecn(1M)
Servers Only disksecn(1M)
NAME
disksecn - calculate default disk section sizes
SYNOPSIS
disksecn [-p-d][
-b block_size ][-n disk_name ]
DESCRIPTION
disksecn is used to calculate the disk section sizes based on the Berkeley disk partitioning method.
disksecn recognizes the following options:
-p Produce tables suitable for inclusion in the device driver.
-d Produce tables suitable for generating the disk description file
/etc/disktab.
-b block_size When generating the above tables, use a sector size of block_size bytes, where
block_size can be
256, 512,
1024,or2048. Defaults to DEV_BSIZE (defined in
<sys/param.h>) if not specified.
-n disk_name Specifies the disk name to be used in calculating sector sizes; for example,
hp7912
or hp7945. If an unknown disk name is specified,
disksecn prompts the user for
the necessary disk information.
If neither
-p nor -d table selection switches are specified a default table of the section sizes and range
of cylinders used is output.
Disk section sizes are based on the total amount of space on the disk as given in the table below (all
values are supplied in units of 256-byte sectors). If the disk is smaller than approximately 44 Mbytes,
disksecn aborts and returns the message disk too small, calculate by hand.
Section 44-56MB 57-106MB 107-332MB 333+MB
0 97120 97120 97120 97120
1 39064 39064 143808 194240
3 39064 39064 78128 117192
4 unused 48560 110096 429704
6 7992 7992 7992 7992
10 unused unused unused 516096
Note
It is important to note the difference between the block size passed into
disksecn
via the -b switch
argument and the sector size the user is asked to input when an unknown disk name is passed to
disksecn via the -n switch argument.
The block size is the sector size that
disksecn assumes the disk to have when it prints the requested
tables. All information printed in the tables is adjusted to reflect this assumed sector size (block size)
passed in by the user. The sector size requested by disksecn when an unknown disk name is passed
does not necessarily have to be the same as the assumed sector size (block size) passed in by the -b
switch argument.
For example, a user wants to see the device driver tables for the disk named
hp7945 with an assumed
sector size (block size) of 256 bytes. The user has the following information about the hp7945 disk:
Disk type = winchester
Sector size = 512
Number of sectors per track (512 byte sectors) = 16
Number of tracks = 7
Number of cylinders = 968
Revolutions per minute = 3600
The user invokes
disksecn by typing the following command:
disksecn -p -b 256 -n hp7945
Assuming that hp7945 is an unknown disk name, disksecn prompts the user for the necessary disk
information. The user should input the information as shown above, reflecting a sector size of 512 bytes.
All the information will be adjusted within disksecn to reflect the assumed sector size (block size) of
256 bytes, passed as the argument of the -b switch, before the requested device driver table is output.
HP-UX 11i Version 3: September 2010 − 1 − Hewlett-Packard Company 1