cplxmodify.1m (2010 09)

cplxmodify(1M) cplxmodify(1M)

The -h option is required if this option is used.

If this option is speciﬁed, the command prompts for a password.

username speciﬁes a conﬁgured user name on the target partition.

Note: This command is a Web-Based Enterprise Management (WBEM) Client Appli-

cation. The

-u option accesses the target partition using a Secure Sockets Layer

(SSL) connection. If errors are reported, check that the conditions described in the

DEPENDENCIES section are satisﬁed.

RETURN VALUE

The

cplxmodify command exits with one of the following values:

0 Successful completion.

1 Error condition occurred.

EXAMPLES

Change the name of the local complex to "Basingstoke".

cplxmodify -N Basingstoke

Change the name of a remote complex to "Ploverleigh". The command prompts for the password.

cplxmodify -N Ploverleigh -g -h RemoteComplex

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and some of its

conﬁguration settings. If you encounter connection errors when using the

-u option, check that the fol-

lowing two conditions are satisﬁed:

• Use the

cimconfig command (see cimconﬁg(1M) in the WBEM product documentation) to verify

(and correct if necessary) the setting of the following two variables:

•

enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• The target partition’s digital certiﬁcate has been appended to the local partition’s Shared Authentica-

tion Store. For the nPartition commands, the Shared Authentication Store is stored in the ﬁle:

/etc/opt/hp/sslshare/known_hosts.pem

. This ﬁle is used by all the clients, which use SSL

based certiﬁcates. If these clients trust a target partition, then the nPartition commands will also

trust the target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

cplxmodify was developed by the Hewlett-Packard Company.