bootconf.4 (2010 09)

b
bootconf(4) bootconf(4)
NAME
bootconf - boot device configuration table
DESCRIPTION
The
/stand/bootconf
file contains the address and disk layout type of the system’s boot devices or lif
volumes. It is used by the
Software Distributor
and HP-UX kernel control scripts (fileset OS-
Core.KERN-RUN
) to determine how and where to update the initial boot loader. Normally the kernel’s
checkinstall script queries the system’s hardware and creates the file. In rare cases when either the
system configuration cannot be automatically determined or additional and/or alternate boot devices
should be automatically updated, the administrator must edit the
/stand/bootconf
file manually.
There is one line in the file for each boot device. Each line contains the following blank-separated fields
in the order shown:
disk type A flag indicating how the file system(s) on the disk are laid out. The flag must be one of the
following:
l Indicates that the root disk is in LVM or VERITAS Volume Manager (VxVM) format. If
LVM or VxVM mirrors are used, then each of the "mirrors" must have its own line in
the file.
w Indicates that the root disk is in the "whole disk" format with no partitions, but boot
and swap space are reserved outside the file system.
device file The absolute path of the device special file that accesses the physical device where the boot
area is located. For LVM root disks, the device special file is the physical volume(s) returned
by the
vgdisplay -v command. For "whole disks" this is the device file that references
the entire disk.
Blank lines are permitted. Any line beginning with a
# is considered to be a comment.
DIAGNOSTICS
The Software Distributor log file
/var/adm/sw/swagent.log
contains diagnostic messages under
the
OS-Core.KERN-RUN
fileset if the bootconf file is incorrect. Most of the messages are self-
explanatory; a few warrant additional explanation:
... is either empty or improperly formatted...
If there are no other messages about bootconf, the file is probably empty. Otherwise, the file is
not in the proper format, and the other messages will explain what the problem is.
device file
... does not contain a valid boot LIF ...
The specified device file does not point to a disk where there is a lif which contains the file
HPUX.
... has an invalid character in the flag field...
Some character other than #, l,orw is in the first field of a line.
... contains contradictory boot LIF types...
As of release 10.0, the boot areas in /stand/bootconf must all be on the same type of disk lay-
out.
... has unrecognized extra characters...
There are characters after the device file specification.
EXAMPLES
The boot area is on an LVM root disk:
l /dev/disk/disk7_p2
The boot area is on a whole disk layout:
w /dev/disk/disk7
WARNINGS
All of the boot devices in the file must have the same disk layout.
AUTHOR
bootconf was developed by the Hewlett-Packard Company.
HP-UX 11i Version 3: September 2010 − 1 − Hewlett-Packard Company 1