acps.conf.4 (2010 09)

a
acps.conf(4) acps.conf(4)
NAME
acps.conf - configuration file for the Access Control Policy Switch (ACPS)
SYNOPSIS
/etc/acps.conf
DESCRIPTION
The ACPS configuration file controls which modules are consulted for making an access control decision,
the order in which the modules are consulted, and the rules for combining their responses to return a
result back to the application.
Syntax and Default Behavior
The
acps.conf file consists of one or more entries in the following format:
Label
:ModuleName:Arguments:Flags
Whitespace in these entries is combined into a single blank (" ") character and removed from the begin-
ning and end of each field. If multiple flags are specified, they should be separated with a comma charac-
ter.
The individual parameters are defined as follows:
Label The label provides a human-readable name for the module entry.
ModuleName The module name identifies the actual shared library to load to effect the authoriza-
tion decision. The module name is specified without a path or a suffix (for example,
.sl), both of which are assumed from the architecture.
Arguments The arguments are defined by the module (that is, module dependent) and are used
to provide additional configuration flexibility.
Flags The Flags field is used to modify the switch’s behavior in interpreting the results
of the module. See Entry Flags for more details and possible values for this field.
The order of the entries in the acps.conf file denote the order in which the modules should be called to
perform the access check. Each entry is called in turn until an "authoritative result code" is returned. In
the currently defined result code, everything except
ACPS_NOINFO is authoritative. Once an authorita-
tive result code is returned by a decision provider module, the code is returned immediately to the appli-
cation. If ACPS_NOINFO is returned, the module is ignored and the next module is referenced.
ACPS_DENY is returned to the application if no module returns an authoritative result.
Entry Flags
In some cases, the default rules for ordering access requests and combining results do not behave as
expected for a particular decision provider module. In this case, it is possible to affect the processing of
the ACPS by specifying one or more of the pre-defined
acps.conf flags. If you specify multiple flags,
you should separate them with a comma character.
There is currently only one flag recognized by the switch. The following flag may be specified on a per-
module basis:
NONATTV Short for ’non-authoritative’, this flag is used for policy modules that always return
authoritative responses, even when they should not. Specifically, NONATTV modifies the
processing of the entry such that a return of ACPS_DENYistreatedas ACPS_NOINFO.
The effect of this is that multiple modules may be stacked with this flag, such that if any
module returns ACPS_ALLOW, then the switch returns ACPS_ALLOW.
EXAMPLES
The following is an example
/etc/acps.conf configuration file. Lines that begin with the # symbol
are treated as comments, and therefore ignored.
# First, attempt to satisfy access request using custom
# module, (e.g. granting all users access to a particular
# object foo, but only between 9am - 5pm). The custom
# module verifies the time and that the object matches
# the specified argument. (In this case, "foo".) If this
# module returns ACPS_DENY, keep going to the next entry
# rather than just returning deny to the application.
HP-UX RBAC : libacpm_timebased : foo : NONATTV
HP-UX 11i Version 3: September 2010 − 1 − Hewlett-Packard Company 1