LDAP-UX Client Services B.05.01 Administrator Guide for HP directory servers and Windows ADS

1.automountMapName ->[nisMapname]
2.automountKey -> [cn]
3.automountInformation -> [nisMapEntry]
Specify the attribute you want to map. [0]:
Enter 0 to exit this menu for the following question:
Specify the attribute you want to map. [0]: 0 Enter
Attribute mappings for dynamic group support
If you are configuring dynamic group support, you must remap the default group member attribute,
memberuid, to memberURL (for HP-UX Directory Server or Red Hat Directory Server). For detailed
information about dynamic group support, see “Dynamic group support” (page 173).
Use the following steps to remap the memberuid attribute to the dynamic group attributes,
memberURL or nxsearchFilter. For example, the following procedures are used to remap
memberuid to memberURL:
1. Enter yes for the following question:
Do you want to remap any of the stantdard RFC 2307 attributes? [yes]:
yes Enter
2. Select the group service by entering 3 for the following question:
Specify the service you want to map? [0]: 3 Enter
3. Next, a screen displays the following information:
Current Group attribute names:
1.cn ->[cn]
2.gidnumber -> [gidnumber]
3.memberuid -> [memberuid]
4.userpassword -> [userPassword]
Specify the attribute you want to map. [0]:
If you want to specify the attribute to map to memberuid, then enter 3 for the following
question:
Specify the attribute you want to map? [0]: 3 Enter
4. Enter the attribute, memberURL or nxsearchFilter that you want to map to the memberuid
attribute:
memberuid —> memberURL Enter
5. Next, a screen displays the following information:
Current Group.attribute names:
1.cn ->[cn]
2.gidnumber -> [gidnumber]
3.memberuid -> [memberURL]
4.userpassword -> [userPassword]
Specify the attribute you want to map. [0]:
To exit this menu, enter 0 for the following question:
Specify the attribute you want to map. [0]: 0 Enter
Attribute mappings for X.500 group membership support
If you want to configure X.500 group membership support, you should remap the group member
attribute to member or uniquemember instead of using the default attribute, memberuid.
Perform the following steps for attribute mappings to set up X.500 group membership:
2.4 Customized installation (setup) for an HP directory server environment 77