LDAP-UX Client Services B.05.01 Administrator Guide for HP directory servers and Windows ADS

• An attempt was made to start or control ldapclientd
without superuser's privileges.
• The ldapclientd daemon process is too busy with
other requests to respond at this time. Try again later.
Message: Problem reading
configuration file.
Meaning: The /etc/opt/ldapux/ldapclientd.conf
file is missing or has a syntax error. If syntax is the problem,
the error message will be accompanied by a line showing
exactly where it could not recognize the syntax or where it
found a setting that is out of range.
7.1.2.6 Warnings
Whenever the system is rebooted, ldapclientd launches if [StartOnBoot] has the parameter
enabled=yes in the file /etc/opt/ldapux/ldapclientd.conf (the ldapclientd
configuation file). Downloading profiles takes time, depending on the server's response time and
the number of profiles listed in the LDAP-UX startup file /etc/opt/ldapux/
ldapux_client.conf.
7.1.3 ldapclientd.conf configuration file
The ldapclientd.conf file is the configuration file for /opt/ldapux/bin/ldapclientd,
the LDAP client daemon. For more information about the client daemon, see Section 7.1 (page 182).
7.1.3.1 Configuration file syntax
# comment
[section]
setting=value
setting=value
.
.
.
[section]
setting=value
setting=value
.
.
.
Where:
comment ldapclientd ignores any line beginning with a # delimiter.
section Each section is configured by setting=value information underneath. The section name
must be enclosed by brackets ("[ ]") as delimiters. Valid section names are:
• StartOnBoot
• general
• passwd
• group
• dynamic_group
• longterm_cache
• netgroup
2
• uiddn
• domain_pwd
• domain_grp
2. LDAP-UX using Windows 2003 R2 or 2008 Active Directory Server does not support netgroup.
184 Administering LDAP-UX Client Services