LDAP-UX Client Services B.04.15 Administrator's Guide

2.12 Configure Subsequent Client Systems
Once you have configured your directory and one client system, you can configure subsequent
client systems using the following steps. Modify any of these files as needed.
1. Use swinstall to install LDAP-UX Client Services on the client system. This does not require
rebooting the client system.
2. Copy the following files from a configured client to the client being configured:
• /etc/opt/ldapux/ldapux_client.conf
• /etc/opt/ldapux/pcred only if you have configured a proxy user, not if you are using
only anonymous access
• /etc/pam.conf
• /etc/nsswitch.conf
• /etc/opt/ldapux/acred if the /etc/opt/ldapux/acred file exists
• cert7.db or cert8.bd and key3.db flles if SSL is enabled
Set all file access mode permission to be the same as those of the first client being configured.
3. Download the profile by running get_profile_entry as follows:
cd /opt/ldapux/config ./get_profile_entry -s nss
Alternatively you could interactively run the setup program to download the profile from
the directory and respond "no" when asked if you want to change the current configuration:
cd /opt/ldapux/config
./setup
4. If you are using a proxy user, configure the proxy user by calling ldap_proxy_config as
follows:
cd /opt/ldapux/config ./ldap_proxy_config
5. Verify the LDAP-UX Client Services (page 61).
2.12 Configure Subsequent Client Systems 63