LDAP-UX Client Services B.04.10 Administrator's Guide (edition 7)

Each services uses a standard object class (defined by RFC 2307)
You can remap any of these attributes to alternate attributes.
Do you want to remap any of the standard RFC 2307 attributes?
Enter “yes” if you want to remap attributes for any of the supported services. Then go to
the “Remapping Attributes for Services” (page 41) section for details of the procedures.
Otherwise, if you do not want to remap attributes for any of the supported services, then
enter “no” to this prompt to continue to step 13 of the setup process.
12. In this step, the setup program initiates a dialog where you can create a custom search
descriptor. A custom search descriptor allows you to specify a different search location or
filter for retrieving entries for services supported by LDAP-UX Client. Each name service
can have up to three different search descriptors. A custom search descriptor consists of
three parts: a search base DN, scope, and filter. The client uses the search descriptors in
order until it finds what it is looking for.
NOTE: If your search filters overlap, enumeration requests will result in duplicate entries
being returned. For example, if one search filter searched a subset of your organization and
a second search filter searched your entire organization, an enumeration request would
return duplicate entries.
See the “Minimizing Enumeration Requests” section for more information.
To begin the process to create custom search descriptors, setup will prompt you for the
following information:
LDAP-UX Client Services supports the following services:
1.Password 7.Networks
2.Shadow passwd 8.Hosts
3.Group 9.Services
4.PAM (Pluggable Authentication Module)10.Printers
5.RPC 11.Automount
6.Protocols 12.Netgroup
You can create up to three custom search descriptors for each name
service to search different locations in the directory for user
and group information.
Do you want to create custom search descriptors? [No]:
Enter 'yes' if you want to create custom search descriptors for any of the supported services.
Then enter the number of the service for which you want to create a custom search descriptor.
If, you do not want to create custom search descriptors, enter 'no' to this prompt to continue
to step 13 of the setup process.
Creating the nisObject Search Filter
LDAP-UX Client Services uses the automount search filter for the automount service as
default. If you want to create the nisObject search filter for the automount service to
search a different location in the directory, use the following steps:
1. Type yes for the following question and press the return key:
Do you want to create custom search descriptors? [No]: yes
2. Next, it will take you to the screen which shows you the following information:
To accept the default shown in brackets, press the Return key.
search base [dc=cup,dc=hp,dc=com]:
search scope (base, one, sub) [sub]
Search filter [(objectclass=automount)]
40 Installing And Configuring LDAP-UX Client Services