LDAP-UX Client Services B.04.00 Administrator's Guide

Installing And Conﬁguring LDAP-UX Client Services

Conﬁgure the LDAP-UX Client Services

Chapter 238

If you want to specify the attribute to map to the

automountInformation attribute , then type 3 for the following

question and press the return key:

Specify the attribute you want to map. [0]:3

8. Next, type the attribute nisMapEntry you want to map to the

automountInformation attribute and press the return key:

automountInformation -> nisMapEntry

9. Next, it will take you to the screen which shows you the following

information:

Current Automount attribute names:

1.automountMapName ->[nisMapname]

2.automountKey -> [cn]

3.automountInformation -> [nisMapEntry]

Specify the attribute you want to map. [0]:

You type 0 to exit this menu for the following question:

Specify the attribute you want to map. [0]:0

If you will be conﬁguring X.500 group membership support, you should

remap the group member attribute (to member or uniquemember) instead

of using the default.

NOTE Make sure that the attribute name is typed in correctly to avoid

unpredictable results later on.

See RFC 2307 at http://www.ietf.org/rfc/rfc2307.txt for a description of

the standard object classes and attributes.

Optionally, you may set up X.500 by executing the following steps:

1. #cd /opt/ldapux/config/

2. Execute the setup program:

#./setup

For the question:

Accept remaining defaults? (y/n) [y]: N

Answer “N” instead of the default “Y”