HP-UX Kernel Cryptographic Module 2.1 User Guide (766149-002, April 2014)

5 Removing HP-UX KCM
This chapter discusses the procedure to remove HP-UX KCM.
To remove HP-UX KCM:
1. Verify whether HP-UX KCM is already installed by running the following command:
swlist –l bundle | grep –i kcm
If HP-UX KCM is already installed on the system, a message similar to the following is displayed:
HPUX-KCM A.02.01.00 HP-UX Kernel Cryptographic Module
2. Remove HP-UX KCM by running the following command:
swremove HPUX-KCM
14 Removing HP-UX KCM