PAM Kerberos v 1.26 Release Notes

Match the result with the fingerprint provided in the Electronic Delivery Receipt. If the
result does not match, download the depot again.
NOTE: The HP-UX MD5 Secure Checksum software is not installed by default on the
system. It is available for download at: http://h20293.www2.hp.com/
14. To install PAM Kerberos v1.26, run the following command at the HP-UX prompt:
# swinstall -s <fully_qualified_depot_source_path>
The swinstall window is displayed.
15. Press the space bar to select the depot name.
16. Select Install in the Action menu.
The Install Analysis window is displayed.
17. Select OK when the Status field displays a Ready message.
The Install window is displayed.
The PAM Kerberos v1.26 software installation starts. The swinstall command loads the
PAM Kerberos files on the system in approximately three to five minutes.
18. Select Done when the Status field denotes Completed.
19. Select File> Exit to exit from the swinstall window.
Verifying the PAM Kerberos v1.26 Installation
To verify whether the PAM Kerberos v1.26 depot is installed successfully on your system, run
the following command:
# swlist -l product PAM-Kerberos
The following output is displayed if the PAM Kerberos v1.26 software is installed successfully
on an HP-UX 11i v1 operating system:
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/tmp/<depot_name>
#
#
# Bundle(s):
#
PAMKerberos B.11.11.16 PAM-Kerberos and Kerberos Support
The following output is displayed if the PAM Kerberos v1.26 software is installed successfully
on an HP-UX 11i v2 operating system:
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/tmp/<depot_name>
#
#
# Bundle(s):
#
PAMKerberos C.01.26 PAM-Kerberos Version 1.26
The following output is displayed if the PAM Kerberos v 1.26 software is installed successfully
on an HP-UX 11i v2 operating system:
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/tmp/<depot_name>
#
10 PAM Kerberos v1.26 Release Notes