PAM Kerberos v 1.24 Release Notes

NOTE: The HP-UX MD5 Secure Checksum software is not installed by default
on the system. It is available for download at: http://h20293.www2.hp.com/
14. To install PAM Kerberos v 1.24, run the following command at the HP-UX prompt:
# swinstall -s <fully_qualified_depot_source_path>
The swinstall window is displayed.
15. Press the space bar to select the depot name.
16. Select Install in the Action menu.
The Install Analysis window is displayed.
17. Select OK when the Status field displays a Ready message.
The Install window is displayed.
The PAM Kerberos v 1.24 software installation starts. The swinstall command
loads the PAM Kerberos files on the system in approximately three to five minutes.
18. Select Done when the Status field denotes Completed.
19. Select File> Exit to exit from the swinstall window.
Verifying the PAM Kerberos v 1.24 Installation
To verify whether the PAM Kerberos v 1.24 depot is installed successfully on your
system, run the following command:
# swlist -l product PAM-Kerberos
The following output is displayed if the PAM Kerberos v1.24 software is installed
successfully on an HP-UX 11i v1 operating system:
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/
#
# PAMKerberos B.11.11.15 PAM-Kerberos and Kerberos Support
PAMKerberos.PAM-Kerberos B.11.11.15 PAM-Kerberos Version 1.24
PAMKerberos.KRBS-Support B.11.11.15 Kerberos Support v1.11
The following output is displayed if the PAM Kerberos v 1.24 software is installed
successfully on an HP-UX 11i v2 operating system:
# Initializing...# Contacting target "localhost"...## Target: localhost:
/tmp/<depot_name>### Bundle(s):#
PAMKerberos C.01.24 PAM-Kerberos Version 1.24
14 PAM Kerberos v 1.24 Release Notes