Kerberos Client Version E.1.6.2.10 Release Notes (December 2012, 5900-2550)

# Target: localhost:/tmp/KRB5CLIENT.depot

# Bundle(s):

KRB5CLIENT E.1.6.2.10 Kerberos V5 Client Version 1.6.2.10

NOTE: When using the swlist and swinstall commands, you must specify the absolute

path of the source depot.

6. On a standalone system, enter the following command to install the Kerberos Client software

bundle:

# swinstall -s /tmp/KRB5CLIENT.depot

The swinstall window is displayed.

7. Select Mark for Install in the Action menu to select the bundle and the patches that you want

to install.

8. Select Install in the Action menu.

The Install Analysis window is displayed.

9. Select OK when the Status Field displays a Ready message.

The Install window is displayed and the Kerberos Client installation starts.

10. Select Done when the Status field displays a Completed message.

11. Select File→Exit to exit from the swinstall window.

Defect Fixes in this Version

The following defects are fixed in Kerberos Client E.1.6.2.10:

QXCR1001092421 Symptom: krb5.h header file is incomplete for 64–bit systems.

Resolution: This issue is resolved.

QXCR1001207198 Symptom: On a HP-UX 11i v3 system, 64–bit Kerberos client library (libkrb5)

fails to reset the password for a Kerberos principal, if the password has

expired.

Resolution : This issue has been fixed.

Enhancements in this version

QXCR1001117059 Symptom: Kdestroy does not delete stale tickets from NFS cache because

ga_cache_table is not updated whenever kinit is done afresh

Resolution : This issue has been fixed.