Kerberos Client Version C.1.3.5.03 Release Notes

Kerberos Client C.1.3.5.03 Release Notes

Installation Requirements for Kerberos Client C.1.3.5.03 on HP-UX 11i v2 September 2004

Chapter 1 15

Installation Requirements for Kerberos Client

C.1.3.5.03 on HP-UX 11i v2 September 2004

This section details the prerequisites for installing Kerberos Client

C.1.3.5.03 on HP-UX 11i v2 September 2004 release.

Hardware Requirements

HP 9000 workstations and servers with a minimum of 32 MB of memory

and sufﬁcient swap space. HP recommends that your servers or

workstations have a minimum of 50 MB of memory.

Operating System Requirements

• HP-UX 11i v2 September 2004 release

Patch Requirements

Install the PHSS_33389 patch before installing Kerberos Client 1.3.5.03

on HP-UX 11i v2 September 2004 release. PHSS_33389 is a core

Kerberos Client patch. You can download PHSS_33389 from

http://www2.itrc.hp.com/service/home/home.do. See “Installing

PHSS_33389 Patch” on page 15 for installation instructions.

Installing PHSS_33389 Patch

You must install PHSS_33389 before installing Kerberos Client

C.1.3.5.03 on HP-UX 11i v2 September 2004 release.

Complete the following steps to install PHSS_33389:

Step 1. Verify if krb5client is installed on your system.

Step 2. If you have krb5client on your system, remove it.

Removing krb5client will restore KRB5-Client (the core product).

Step 3. Install PHSS_33389.

Step 4. Install Kerberos Client C.1.3.5.03 on your system.