Installing, Configuring and Administering the Kerberos Server V 2.0 on HP-UX 11i

Installation
Installing The Kerberos Server
Chapter 238
Installing The Kerberos Server
If you are migrating your Kerberos database from version 1.0 to the
new version, version 2.0, create a dump file of the older Kerberos
database before installing the new version of HP’s Kerberos Server.
Refer to Chapter 3, “Migration,” on page 41.
Step 1. Insert the software media (tape or disk) in the appropriate drive
Step 2. Type: swinstall
See the man page on swinstall (1m) for more information on this
command
Step 3. Click on OK on the “Specify Source” window.
Step 4. Highlight T1417AA in the ‘Software Selection’ dialog,then select ‘Mark
For Install’ from the ‘Actions’ menu to install all filesets in the
bundle.
Step 5. When you have marked the product components you want to install,
select ‘Install (analysis)’ from the ‘Actions’ menu.
Step 6. When you have successfully completed the analysis, click on OK from the
‘Analysis’ dialog to load the Kerberos Server filesets.
If you are migrating your Kerberos database from version 1.0 to version
2.0, the following message is displayed:
The kerberos database dump file needs to be created before you
go ahead with this installation. If this is a migration from
Kerberos Server Ver 1.0 to Kerberos Server 2.0, refer to the
section Migration, in the Installing, Configuring and
Administering the Kerberos Server on HP-UX 11i.
The swinstall utility loads the filesets. Estimated time for processing is
five minutes.
If the installation is not successful, an error message is displayed. The
cause of the failure will appear at the end of /var/adm/sw/swagent.log
file.