Configuration Guide for Kerberos Client Products on HP-UX 11.0 | HP-UX 11i v1 | HP-UX 11i v1.6 | HP-UX 11i v2

Introduction to the Kerberos Products and GSS-API
PAM Kerberos
Chapter 242
[NOTICE] These messages are logged to notify the user about the
erroneous lines in the PAM configuration files or notify
about the skipping of /etc/pam_user.conf file
validation.
[FAIL] These messages are logged when any of the above
mentioned validation fails.
[PASS] These messages are logged when any of the above
mentioned validation succeeds.
[IGNORE] These messages are logged when validation of the
/etc/krb5.keytab is ignored.
ERROR These messages are logged to informthe user about the
exact problem in the PAM configuration files
[HELP] These messages will give some minimal help to the
user to rectify the problem.
If there are any [FAIL] or ERROR messages then there is some problem
in the appropriate section. The administrator should diagnose the
problem.
OPTIONS
-v[erbose] verbose output
-a {pa32 | pa64 |ia32 | ia64}
Depending on the architecture on which the validation
need to be done this option needs to be set. The flags
available are as listed below:
pa32 for PA 32-bit architecture
pa64 for PA 64-bit architecture
ia32 for Itanium 32-bit architecture
ia64 for Itanium 64-bit architecture
Depending on this flag, $ISA in the module_path will
be expanded as explained above.