HP-UX iSCSI Software Initiator Release Notes Revision B.11.31.
© Copyright 2010 Hewlett-Packard Development Company L.P Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Table of Contents 1 HP-UX iSCSI Software Initiator Release Notes.............................................................5 Announcement.......................................................................................................................................5 Availability of Documentation...............................................................................................................5 What’s New....................................................................................
List of Tables 1-1 4 HP-UX iSCSI Software Initiator Support Matrix............................................................................
1 HP-UX iSCSI Software Initiator Release Notes Announcement The HP-UX iSCSI Software Initiator is a software implementation of the iSCSI protocol (RFC 3720) based on the HP-UX host TCP/IP stack. The iSCSI protocol defines a mass storage transport wedge between TCP and the SCSI Services layer. The HP-UX iSCSI Software Initiator is compliant with RFC 3720. To access the IETF iSCSI Specification RFC 3720, go to: http://www.ietf.org/rfc/rfc3720.
Revision B.11.31.03 of the HP-UX iSCSI Software Initiator includes the following new feature: • Resolved the issue that reported the incorrect residual count to the application while performing I/O with Disk-to-Disk (D2D) tape targets (QXCR1000993182). This fix enables support for the D2D family of backup systems. For the information of the D2D device models supported, see the support matrix at: http://docs.hp.com/en/iSCSI_SM/ iSCSISupportMatrix.pdf.
• Problem: The scsimgr command displays iSCSI port and node names in hex format instead of ASCII format. Therefore, this information is not useful. Workaround: This issue will be corrected in a subsequent release of the scsimgr command. • Problem: When performing an OE update from HP-UX 11i v2 to HP-UX 11i v3 using Update-UX, the iSCSI product is not installed properly. Workaround: Remove and reinstall the iSCSI Software Initiator on HP-UX 11i v3 after the update.
HP-UX iSCSI Software Initiator Support Matrix NOTE: The following support matrix reflects the support status of Revisions B.11.31.xx of the HP-UX iSCSI Software Initiator, at the time these Release Notes were published. The HP-UX iSCSI Software Initiator Support Matrix located at http://www.docs.hp.com, is regularly updated with the latest support status on all supported revisions of this product.
