HP-UX iSCSI Software Initiator B.11.31.02 Release Notes (September 2009)

• Problem: The scsimgr command displays iSCSI port and node names in hex format instead
of ASCII format. Therefore, this information is not useful.
Workaround: This issue will be corrected in a subsequent release of the scsimgr command.
• Problem: When performing an OE update from HP-UX 11i v2 to HP-UX 11i v3 using
Update-UX, the iSCSI product is not installed properly.
Workaround: Remove and reinstall the iSCSI Software Initiator on HP-UX 11i v3 after the
update. This issue might be corrected in a subsequent release.
Installation Requirements
The following patches, or any superseding patches, must be installed along with revision B.11.31.02
of the HP-UX iSCSI Software Initiator:
• PHKL_36332
• PHKL_36334
No patches are required for systems running HP-UX 11i v3, September 2007 Release or later
versions.
Installation Requirements 7