HP-UX iSCSI Software Initiator Release Notes Revision B.11.31.
© Copyright 2009 Hewlett-Packard Development Company L.P Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Table of Contents 1 HP-UX iSCSI Software Initiator Release Notes.............................................................5 Announcement.......................................................................................................................................5 Availability of Documentation...............................................................................................................5 What’s New....................................................................................
List of Tables 1-1 4 HP-UX iSCSI Software Initiator Support Matrix............................................................................
1 HP-UX iSCSI Software Initiator Release Notes Announcement The HP-UX iSCSI Software Initiator is a software implementation of the iSCSI protocol (RFC 3720) based on the HP-UX host TCP/IP stack. The iSCSI protocol defines a mass storage transport wedge between TCP and the SCSI Services layer. The HP-UX iSCSI Software Initiator is compliant with RFC 3720. To access the IETF iSCSI Specification RFC 3720, go to: http://www.ietf.org/rfc/rfc3720.
New features in Revision B.11.31.02 of the HP-UX iSCSI Software Initiator include: • Resolved the issue that affected the discovery and configuration of iSCSI devices by VxVM (QXCR1000932601). In the previous release, the init script was not invoked properly. Limitations The following information is for revision B.11.31.02 of the HP-UX iSCSI Software Initiator.
• Problem: The scsimgr command displays iSCSI port and node names in hex format instead of ASCII format. Therefore, this information is not useful. Workaround: This issue will be corrected in a subsequent release of the scsimgr command. • Problem: When performing an OE update from HP-UX 11i v2 to HP-UX 11i v3 using Update-UX, the iSCSI product is not installed properly. Workaround: Remove and reinstall the iSCSI Software Initiator on HP-UX 11i v3 after the update.
HP-UX iSCSI Software Initiator Support Matrix NOTE: The following support matrix reflects the support status of Revisions B.11.31.02 of the HP-UX iSCSI Software Initiator, at the time these Release Notes were published. The HP-UX iSCSI Software Initiator Support Matrix located at http://www.docs.hp.com, is regularly updated with the latest support status on all supported revisions of this product.
