IPv6 Release Notes

10. Select the IPv6Upgrade bundle depot under Download Software.
11. Save the IPv6Upgrade bundle depot in a local directory, for example, /tmp.
12. To verify that the IPv6Upgrade bundle depot is downloaded properly in the
local directory, enter the following HP-UX MD5 Secure Checksum command at
the HP-UX prompt:
# md5sum <depot_name>
The result of this command must match the fingerprint provided in the Electronic
Delivery Receipt. If the result does not match, download the IPv6Upgrade bundle
depot again.
NOTE: The HP-UX MD5 Secure Checksum software is not installed by default
on the system. To download the software, see the HP-UX MD5 Secure Checksum
software:
http://h20293.www2.hp.com/
13. To install the IPv6Upgrade bundle depot, enter the following command at the
HP-UX prompt:
# swinstall -s <fully_qualified_depot_source_path>
The swinstall window is displayed.
14. Press the space bar to select the product that you want to install.
15. Select Install in the Action menu. The Install Analysis window is displayed.
16. Select OK when the Status field displays a Ready message. The Install window is
displayed.
The IPv6Upgrade bundle software installation starts. The swinstall command
loads the IPv6Upgrade bundle files on to the system in approximately 3 to 5
minutes.
17. Select Done when the Status field displays a Completed message.
18. Select File->Exit to exit from the swinstall window.
Verifying the IPv6Upgrade Bundle Installation
To verify whether the IPv6Upgrade bundle depot is installed successfully on the
HP-UX 11i v3 system, enter the following command at the HP-UX prompt:
# swlist -l product IPv6Upgrade
If the IPv6Upgrade bundle is installed properly, the following output is displayed:
# Initializing...
# Contacting target "hosta"...
#
# Target: hosta:/
#
14 IPv6 Release Notes