IPv6 Release Notes

NOTE: The IPv6Upgrade bundle sets this
tunable to 2 to enable the RFC 3810 functionality.
ip6_addr_sel_enable
Enables or disables RFC 3484. This tunable
specifies the default address selection for IPv6.
The default value of this tunable is 0.
NOTE: The IPv6Upgrade bundle sets this
tunable to 1 to enable the RFC 3484 functionality.
ip6_icmp6_extended_errors
Specifies whether to report additional ICMPv6
error messages as defined in RFC 4443. The
default value of this tunable is 0.
NOTE: The IPv6Upgrade bundle sets this
tunable to 1 to enable the RFC 4443 functionality.
ip_igmp_version
Controls the IGMP protocol version used by the
system. The default value of this tunable is 2.
NOTE: The IPv6Upgrade bundle sets this
tunable to 3 to enable the RFC 3376 functionality.
ip6_nd_use_temp_address
Controls the generation of IPv6 temporary
addresses as defined in RFC 4941. The default
value of this tunable is 0.
NOTE: The IPv6Upgrade bundle sets this
tunable to 1 to enable the RFC 4941 functionality.
ip6_nd_temp_valid_lifetime
Controls the upper limit of valid lifetime for IPv6
temporary addresses configured using router
advertisements. The default value of this tunable
is 604800 (1 week).
ip6_nd_temp_preferred_lifetime
Controls the upper limit of preferred lifetime for
IPv6 temporary addresses configured using
router advertisements. The default value of this
tunable is 86400 (1 day).
ip6_nd_prefer_temp_address
Controls the source address selection preference
to use an IPv6 temporary address instead of a
public IPv6 address
New ndd Tunables 11