HP-UX Mobile IPv6 A.01.00 Administrator's Guide

Chapter 4
Creating Mobile IPv6 Kernel Module Configuration Files with the mip6config Tool
mip6mod Error Rate Parameters
56
mip6mod Error Rate Parameters
Use the mip6config commands described in this section to configure the mip6mod Error Rate Parameters.
Refer to “mip6mod Error Rate Parameters” on page 33, for a description of each parameter. The mip6mod
Error Rate parameters include the following:
• Error Rate Threshold
•Max. Rate Limit
•Min. Rate Limit
Configuring mip6mod Error-Rate Parameters: configure error-rates
Use the configure error-rates command to configure mip6mod Error Rate parameters in Novice Mode.
Abbreviated: co[nfigure] e[rror-rates]
Syntax: configure error-rates
Example: mip6config> configure error-rates
Error Rate Threshold (10): 25
Max Error Rate (75): 250
Min Error Rate (1000): 500
Listing mip6mod Error Rate Parameters: list error-rates
Use the list error-rates command to display mip6mod Error Rate parameters.
Abbreviated: l[ist] e[rror-rates]
Syntax: list error-rates
Example: ERROR RATE PARAMETERS
**********************************************************************
Error Rate Threshold: 25
Max Error Rate: 250
Min Error Rate: 500
Deleting mip6mod Error Rate Limit Parameters: delete error-rates
Use the delete error-rates command to delete mip6mod Error Rate parameters. This command sets the
mip6mod Error Rate parameters as unconfigured (i.e., empty) by “commenting” the value in the configuration
file. You must confirm you want to delete the Error Rate parameters when prompted.
Abbreviated: d[elete] e[rror-rates]
Syntax: delete error-rates
Example: mip6config> delete error-rates
Clear all error rate parameters (yes/no)? (yes): yes