HP-UX IPv6 Transport Administrator's Guide for TOUR 1.0

Utilities
Configuration Utilities
Chapter 544
Configuration Utilities
This section describes configuration utilities available to configure
HP-UX 11i IPv6 bundled as part of TOUR 1.0.
New ifconfig “inet6” address family
Use ifconfig to assign an IPv6 address to an interface and configure
parameters, such as the network prefix. (InIPv6, prefix replaces
netmask.)
The new ifconfig keyword inet6 is required to configure IPv6
interfaces. It is not required to examine IPv6 interfaces. Refer to the
ifconfig(1M) man page for details.
Neighbor Discovery Protocol Replaces arp in IPv6
The Neighbor Discovery Protocol (ndp) replaces arp in IPv6. Refer to
“Neighbor Discovery” on page 55 in Chapter 6 for details.
New “inet6” route Option
route(1M) adds and deletes entries to the network routing table,
allowing your system to communicate through a router. In IPv6, routing
entries are automatically added when router advertisements are
received from an IPv6 router. A configured tunnel route can be added
using the route utility. Refer to route(1m) for more information.