HP-UX IPv6 Transport Administrator's Guide for TOUR 1.0

Troubleshooting
Diagnostic Flowcharts
Chapter 4 31
Flowchart 1 Procedures
A. Execute: telnet <hostname> to remote host . Try to connect using
telnet to a remote host.
B. Succeeds? If telnet succeeds, stop. The system connects using TCP6 over
IPv6 through the Transport Layer (OSI Layer 4).
C. Connection Refused? Trying to connect to a remote system where HP-UX 11i
IPv6 is not installed can cause this message.
D. Network Reachable? If it is, go to F, otherwise continue to E.
E. Check for Network Connectivity. Ensure network connectivity by following
the steps in Flowchart 2.
F. Ensure IPv6 installed on remote node. If telnet still fails, check the
etc/inetd.conf file.